1
00:00:08,000 --> 00:00:10,200
Welcome to Biertap.eu.

2
00:00:10,300 --> 00:00:13,400
Today I am going to show you how to connect 
your beer cooler to a beer keg.

3
00:00:13,500 --> 00:00:15,100
I have all the parts here.

4
00:00:15,200 --> 00:00:19,300
The beer tap, a mini co2 bottle with a co2-metre,

5
00:00:19,400 --> 00:00:24,200
The dispense head, tubes, and of course the 
beer keg!

6
00:00:24,300 --> 00:00:29,700
At first we take the dispense head and connect 
them to the John Guest connector.

7
00:00:29,800 --> 00:00:34,600
This is to make the connection with the beer 
keg.

8
00:00:36,000 --> 00:00:44,500
Next up, this John Guest connector. This 
one goes at the side of the dispense head, 
and is for the CO2 connection.

9
00:00:46,400 --> 00:00:49,000
Screw them hand-tide, that’s more than enough.

10
00:00:49,100 --> 00:00:57,100
And this little connector goes on the CO2 
metre.

11
00:00:58,000 --> 00:01:03,000
And here goes the same; hand-tide is more 
than enough.

12
00:01:05,400 --> 00:01:09,100
After that we’ll take the beer tube…

13
00:01:12,600 --> 00:01:23,000
After you prepared the dispense head and 
all the tubes, you’ll connect the beer tube 
in the back of the beer cooler.

14
00:01:25,000 --> 00:01:27,600
Make sure you’ll press it well until it ‘pops’.

15
00:01:29,300 --> 00:01:40,500
We’ll turn the beer dispenser and we’ll take 
our dispense head. If it’s up, it’s open.

16
00:01:40,600 --> 00:01:45,400


17
00:01:45,500 --> 00:01:50,300


18
00:01:50,400 --> 00:01:53,500
After that, you’ll connect it on the beer 
keg.

19
00:01:53,600 --> 00:01:57,100
Turn the dispense head a little.

20
00:01:57,200 --> 00:02:04,600
You’ll connect the cooler with electricity 
after you’ve connected the beer keg.

21
00:02:04,700 --> 00:02:07,600
After that you’ll need to tweak the pressure 
with the CO2 bottle.

22
00:02:07,700 --> 00:02:15,400
With a dry cooler, in this case a Pygmy 25, 
it’s a good idea to start with a bar of 2,3.

23
00:02:15,500 --> 00:02:20,300
I’m going to set it a little bit higher.

24
00:02:20,400 --> 00:02:23,000


25
00:02:23,100 --> 00:02:28,500
Now we’ll wait until the cooler stalls, then 
it will be on the right temperature.

26
00:02:28,600 --> 00:02:32,000
With a dry cooler like this, it would be 
about 5 minutes.

27
00:02:32,100 --> 00:02:36,900
And then you’ll be ready to tap some beers!